Three important examinations before installing the tripod turnstile gate

26-06-2019
The tripod turnstile gate is a safe and intelligent channel access control device.
The tripod turnstile gate with simple structure and quick convenient maintenance.
The tripod turnstile gate is so affordable and cost-effective.
It can also save security management. The equipment runs very smooth, quiet, efficient, and saves space. It meets general requirements such as factories, communities, construction sites, gymnasiums, etc.


But Many companies are not so familiar with the installation of tripod turnstile gate.

Here we would like to give some specific precautions and installation techniques.
We must do examinations before we install the tripod turnstile like the below 3 aspects:

1. Motor examination:
Before the installation, the no-load current should be under 500mA.
And the starting working distance of the motor should meet the requirements of use. This little detail needs attention.

2. System examination:
We must ensure the mechanical part is not stuck and the operation is flexible.
Because the mechanical operation is the only power source in this system. It must with a normal working ablility.

3. Check the wiring:

 Why check the wiring?  Many people may think that this is a small problem, but in fact, not paying attention will cause a lot of trouble. Thus, refere the wiring diagram of automatic tripod turnstile gate. Check the wiring of the motor.

Only after all connections are contact well, we can energize it.

Other access control system should do the same examination. 

Like speed gate, flap barriers, swing barriers, full height turnstile, Bollard etc.




Nhận giá mới nhất? Chúng tôi sẽ trả lời sớm nhất có thể (trong vòng 12 giờ)

Chính sách bảo mật